Respectable progress has been made on the 3-in-1 sailboat. After sketching the pieces on ACX plywood, we pulled out the jigsaw. I had no prior experience with a jigsaw so my initial cuts weren't too pretty, but I quickly got the hang of it. I bonded with each of the brothers, getting "jiggy" with the jigsaw. Observe Jeff and I getting it done in the backyard as twilight fell.
We cleared out the artificial trees in the garage (decorations for Jean and Sean's open house tomorrow) so we could set up the table saw, miter saw, and the stationary sander. Assembly was postponed until tomorrow because the wrong screws were purchased. Despite that fact, tomorrow should be very productive. This is the garage in its current state.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.